ST-PFS/ST-PFS-M - Timber Frame Holding Down Straps

The ST-PFS stainless steel strap is an engineered solution to restrain timber structures against uplift when using either timber joists, engineered joists or concrete ground floors. The straps are available to suit 50, 75 & 100mm cavities.

ST-PFS Datasheet

SP/SPU - Sole Plate Anchors

The SP-90 locates and anchors timber sole plates.

The SP-240 should be used in situations where it is necessary to provide a greater amount of fixings to the base material.

The SPU is to be fixed to the base material at suitable locations prior to the fixing of the sole plate. The SPU is then fixed to either side of the sole plate to provide a secure connection.

SP/SPU Datasheet

RST-3 - Lateral Restraint To Gable Panels

The RST-3 Strap provides a convenient and secure method of fixing gable panels to the roof trusses. It can be used as an equivalent to 30x5 or 30x2.5mm straps for this application.

RST-3 Datasheet

IR-Clip - Insulation Retaining Clip

The IR-Clip allows for the use of high performance ridge insulation and is available to suit most insulation and timber stud sizes.

IR-Clip Datasheet

AWS - Acoustic Wall Strap

Improved timber strap for connecting separating walls in attached dwellings, with superior strength and acoustic properties.

AWS Datasheet

PWS - Party Wall Strap

The PWS strap is a standard timber frame strap for connecting separating walls in attached dwellings. Supplied in 2 sizes - 220mm & 240mm.

PWS Datasheet

PC - Panel Closer

The PC is used for drawing panels together in closed panel construction.

PC Datasheet

LL - LedgerLok - Open Panel Construction

Quickly and easily connects timber frame panels together.

LL Datasheet

HRA - Head Restraint Anchor

The HRA secures the head of non-load bearing partitions without transmitting unwanted loads into the frame.

HRA Datasheet

RD-DCR - Range
The RD-Range was developed for joist to rim connections. The design concept is that the floors are constructed as normal with the joists bearing onto the wall panel and the RD-DCR is then fixed into position to restrain the joist. In the event of a disproportionate collapse situation arising (fire, explosion, etc). The RD-DCR, although not normally used as a hanger, will act as a hanger to transfer the floor load tot he rim beam which will have been designed to carry this load across the length of the panels.

RD-DCR Range Datasheet

HIFI - High Load Internal Flange Hanger
The HIFI hanger can be used in two different applications:

-High load timber to timber connections.

-As part of a complete engineered solution, to prevent the occurrence of disproportionate collapse in multi-storey timber frame buildings.

HIFI Datasheet

FT - Wall Tie

Wall tie range to suit nominal cavity widths of 50, 75 & 100mm.

FT Datasheet

HMT - High Movement Wall Tie

The HMT is a high performance wall tie that allows the differential movement in medium to high-rise structures to be accommodated.

The HMT range is a two-piece design with the channel section being fitted plumb to the structure and secured with two standard wall ties nails. The tie element interlocks and provides a sliding arrangement which does not cause the historic binding problems normally associated with dovetail type ties when used in timber frame.

HMT Datasheet